Chapter 6. System Control Terminal Menus61200305L1-1 ATLAS 550 User Manual 6-11SNMPC OMMUNITIESWrite security: 3; Read security: 5Defines SNMP manager(s) characteristics as follows:IP ADDRESSSpecifies the IP address of the network manager.P RIVILEGESDefines G ET (read-only) and G ET/S ET (read and write) privileges.G ET N AMEDefines the community name for G ET access. This value must match theG ET name defined on the network management station. P UBLIC is thedefault name.S ET N AMEDefines the community name for S ET access. This value must match eitherthe G ET or S ET name defined on the network management station. P UBLICis the default name.TRAPTRANSMISSIONWrite security: 2; Read security: 5Enables and disables SNMP trap transmission.AUTHEN TRAPTRANSMISSIONWrite security: 3; Read security: 5Enables and disables the authentication failure trap.TRAPSD ESTINATIONRead security: 5Defines the destination for SNMP traps as follows:IP ADDRESSWrite security: 3; Read security: 5Identifies the IP address to which the network manager sends traps.C OMMUNITYWrite security: 3; Read security: 5Defines the community name for trap destinations. This name must matchthe community name defined at the network management station.T RAP F ILTERINGWrite security: 2; Read security: 5Sets the minimum severity level required for a system event to generate anSNMP trap. If a trap event occurs and if the trap’s severity level is equal toor more severe than the trap type’s current threshold setting, that event issent as an SNMP trap. (Refer to the ATLAS 550 MIB for a listing of all trapsand their severity levels.) You can set the following threshold levels for theavailable selections: D ISABLED , C RITICAL , M AJOR, M INOR, WARNING , N OR -MAL, and INFO.S TATION T YPEWrite security: 3; Read security: 5To deliver the SNMP trap packet with the C OMMUNITY N AME unchanged,define the S TATION TYPE as N ORMAL. If you are using T-Watch PRO, define
