AEG BES351010M User Manual

Also see for BEB351010B: User manual

2. Fully lift up the clamping levers (A) onthe two door hinges.AA3. Close the door until it is at an angleof approximately 45°.45°4. Hold the door with one hand on eachside and pull it away from theappliance at an upwards angle.5. Put the door with the outer sidedown on a soft cloth on a stablesurface. This is to prevent scratches.6. Hold the door trim (B) on the topedge of the door at the two sidesand push inwards to release the clipseal.12BCAUTION!Rough handling of the glass,especially around the edgesof the front panel, can causethe glass to break.7. Pull the door trim to the front toremove it.8. Hold the door glass panels on theirtop edge one by one and pull themup out of the guide.9. Clean the glass panel with water andsoap. Dry the glass panel carefully.When the cleaning is completed, do theabove steps in the opposite sequence.Install the smaller panel first, then thelarger and the door.WARNING!Make sure that the glassesare inserted in the correctposition otherwise thesurface of the door mayoverheat.10.7 Replacing the lampPut a cloth on the bottom of the interiorof the appliance. It prevents damage tothe lamp glass cover and the cavity.WARNING!Danger of electrocution!Disconnect the fuse beforeyou replace the lamp.The lamp and the lamp glasscover can be hot.1. Deactivate the appliance.2. Remove the fuses from the fuse boxor deactivate the circuit breaker.The top lamp1. Turn the lamp glass covercounterclockwise to remove it.2. Clean the glass cover.www.aeg.com28