Flash Code Possible Meanings of Flash CodeLED Remains On Host Adapter Control Processor inoperative, terminators missingor not powered, or card enable has not been asserted after reset.1 Flash RAM test failed.2 Flashes AIC-6251 SCSI protocol chip verification failed.3 Flashes FIFO write/read data path test failed.Continuous Flashes EEPROM has not been programmed.ASW-C174 Configuration DisketteThe AHA-1740A/1742A/1744 is normally supplied with configuration software, prod-uct number ASW-C174. This includes 5.25-inch and 3.5-inch high-density diskettesand an installation guide. The two diskettes contain identical information. The func-tions of the files on the diskette may be supplied as part of the system utilities for thehost system in which the AHA-1740A/1742A/1744 is installed. The configuration disk-ette contains the following files:•!adp0000.cfg - Configuration file for the AHA-1740 (older version of theAHA-1740A)•!adp0400.cfg - Configuration file for the AHA-1744•!adp0001.cfg - AHA-1740A/1742A with floppy disabled•!adp0002.cfg - AHA-1742 with floppy enabled•!adp0100.cfg - AHA-1540B/1542B configuration file•!adp0000.ovl - Configuration overlay file for SCSI bus parameters•adl.exe - Microcode download utility, including low-level format utility•standard.hex - Current production release of Standard Mode microcode(AHA-1740/1744 only)•enhanced.hex - Current production release of Enhanced Mode microcode(AHA-1740/1744 only)Earlier versions of ASW-C174 may not contain all features listed. Operation of theutilities is described in Chapter Three, Installation and Chapter Ten, Problem Deter-mination. If the board has no ASW-C174 accompanying it, or the utility is incompleteand the system utilities do not include the function needed, either contact the boardvendor for a copy or query the Adaptec bulletin board for a download copy of the files.NoteThe Adaptec bulletin board number is (408) 945-7727. Use 8 data bits, 1 stop bit,no parity, 1200, 2400, or 9600 baud.adaptec AHA-1740A/1742A/17442-12
