Enhanced Mode SCSI ConfigurationThe view for Enhanced Mode allows more flexible selection and is shown inFigure 3-6.The enhanced mode offers a greater selection of SCSI configuration options. Use theTab or Cursor keys or a mouse to highlight a particular selection and press Enterto toggle between no and yes. Each device can have a number of parameters selectedindividually.Error if Device Not Found selects whether the operator will be notified if theBIOS is unable to find the device during the boot procedure.BIOS Support Option allows up to two devices attached to the SCSI bus to be rec-ognized by the host adapter BIOS and installed as devices on the system without theneed for driver software. Only fixed and removable hard disks are supported underthe BIOS, with default for hard disks only. Select this option to allow removable sup-port or to remove any disk support for each SCSI address. Note that support for re-movable disks does not allow the disk media to be removed during operation, onlyuse of a removable disk as if it were a fixed disk.When this option is selected, use the cursor keys to move among the options shown inFigure 3-7.SCSI Device ID #0 #1 #2 #3 #4 #5 #6 #7Error if Device Not Found no no no no no no no noBIOS Support Option HD HD HD HD HD HD HD noSend Start Command no no no no no no no noEnable Parity Check yes yes yes yes yes yes yes yesInitiate SynchNegotiation yes yes yes yes yes yes yes yesEnable Disconnection yes yes yes yes yes yes yes yesMaximum Synch Xfer Rate 10.0 10.0 10.0 10.0 10.0 10.0 10.0 10.0(MBs per second)System Configuration Detailed View F1=HelpSystem Edit View Settings HelpHost Adapter Interface Mode ..........Enhanced ModeSlot 4Configuration Settings for SCSI DevicesOk Figure 3-6. Enhanced Mode SCSI Configuration Screenadaptec AHA-1740A/1742A/17443-12
