Adaptec P2280A Manual

Also see for 39160: Installation guide Manual

Contents

5-2Ultra160 Family Manager Set User’s GuideInstalling the Driver When Installing UnixWareTo install either theadst21 oradst70 driver at the same time youinstall UnixWare, follow the instructions below. The procedures arethe same for UnixWare 2.1x and 7.01/7.1.1 Insert the Install disk of the UnixWare package into the bootfloppy disk drive. Reboot your computer.Wait for the first UnixWare installation screen and prompt toappear, then follow the on-screen instructions.2 When prompted to either Install Host Bus Adapter Drivers orContinue Installation, first remove the Install disk, then selectInstall Host Bus Adapter Driver and press Enter.3 Insert the Ultra160 Family Manager Set disk for UnixWare 2.1xor 7.1 into the primary floppy disk drive and press Enter (youcannot load drivers from a secondary floppy disk drive).As the driver loads, a message identifying the installed hostadapter briefly appears on screen. The installation processdetermines which device drivers on the disks are needed.4 If you have additional HBA disks, insert the next HBA disk,select Install Another HBA Disk, and press Enter.If all of your HBA disks have been installed, remove the lastHBA disk, select Continue Installation, and press Enter.5 If necessary, enter the DCU (Device Configuration Utility) toview/change the UnixWare device driver configuration data.6 Follow the on-screen instructions to continue with installation.Refer to the UnixWare documentation and on-screen help filesfor help in selecting options.Note: If your installation fails, do not attempt to use theupdate installation pkgadd procedure to fix the installation.Follow the instructions in the UnixWare documentation andin this User’s Guide to retry the installation.