Configuration PossibilitiesAXIS 5400+ / AXIS 5600+ Userís Manual 113To enable these protocols, select Admin | Network Settings | DetailedView | TCP/IP Network for FTP, Telnet, AutoIP, DHCP and BOOTP.Remote Config is enabled via Admin | General Settings | RConfigSupport.Important:CheckingSSL/TLS StatusTo check SSL/TLS status, open the print serverís Web interface and selectAdmin | Network Settings | Detailed View | TCP/IP Network to see if theHTTPS Enabled parameter is set to Yes or No.To View a Certificate To view a Certificate, open the print serverís Web interface, select Admin| Security Settings and click View next to the Certificate.To Delete a Certificate To delete a Certificate, open the print serverís Web interface, select Admin| Security Settings and click Delete next to the Certificate.Enabling the SNMPv3 ProtocolInvoke the print serverís Web interface to enable the SNMPv3 protocol.1. Select Admin | Network Settings | Detailed View | TCP/IP NetworkAdmin | Network Settings | Detailed View | TCP/IP NetworkAdmin | Network Settings | Detailed View | TCP/IP NetworkAdmin | Network Settings | Detailed View | TCP/IP Network andensure that HTTPS EnabledHTTPS EnabledHTTPS EnabledHTTPS Enabled is set to yesyesyesyes to guarantee a secureconfiguration.Note: You must have a valid certificate loaded to be able to enable HTTPS.See ìEnabling SSL via the Web Interfaceî on page 111.To ensure maximum security, it is highly recommended that you change your Administratorpassword after generating a certificate and disabling insecure protocols! This is done fromAdmin | General Settings | Change => | General | Root Password.
