Axis 5400+ User Manual
Also see for 5400+: SpecificationUser guideInstallation guideUser guideUser manual
                                                                                                                                                                    | |
Contents
| 
The Test Button126 AXIS 5400+ / AXIS 5600+ Userís ManualSection 14 The Test ButtonThe test button is located on the front right hand side of the AXIS5400+/AXIS 5600+ and is used for:ï Printing a test page to check the connection to the printer.ï Printing a parameter list to see the print serverís current settings.ï Performing a Factory Default of the print server.If you want to change any of the parameters, use one of the methodsdescribed in Management and Configuration, on page 83.Printing a Test Page Press the test button once to print a test page. The test page containsbasic information about the AXIS 5400+/AXIS 5600+. It is recommendedthat you print a test page every time you connect the print server to aprinter.Note:Printing theParameter ListPress the test button twice to print a parameter list showing the currentAXIS 5400+/AXIS 5600+ settings. This list provides comprehensivedetails of all the parameters and their current status. Refer to Section 17The Parameter List, on page 134.Performing a FactoryDefault1. Remove the external power supply to switch off the print server.2. Press and hold down the test button while you reconnect the external powersupply.3. Continue to hold down the test button until the network indicator remainsconstantly lit. This should take about 20 seconds.4. Restart the print server by disconnecting and reconnecting the externalpower supply.For AXIS 5600+: if just one of the ports is connected to a printer, the test page will be printedon that port. If each port is connected to a printer, the default setting is to send the test pageto 1) LPT1, 2) COM1, 3) LPT2. The default behavior can be changed from the print serverísinternal Web pages under Admin | General Settings => Change.For print servers with firmware version 6.43 and higher, a Factory Default willreset all print server parameters and settings to their default values, except:ïInstalled certificateïPrivate key |
Related manuals for Axis 5400+
manualsdatabase
Your AI-powered manual search engine