Adding Printers in NetWare42 AXIS 5400+ / AXIS 5600+ Userís ManualSection 6 Adding Printers in NetWareThis section describes how to continue the installation of the AXIS5400+/AXIS 5600+ in the NetWare environment. Identify which transportprotocol you are running on your network and which installation methodyou should use. Continue the installation by selecting the appropriateinstalling instructions from the table below:See ìNetWare Administrationî on page 66 for information on Novellísadministration tools.If you intend to operate your AXIS 5400+/AXIS 5600+ in a multi-protocol, mixed environment, you should also proceed to the otherrelevant sections in this manual.InstallationmethodTransportprotocol ActionNDPS TCP/IPIPX/SPXSee ìSetup using NDPSî on page 43 andìPublic Access Printersî on page 44ìControlled Access Printersî on page 48iPrintiPrint over LPRSee ìSetup using iPrintî on page 57 andìInstall a printer using AXIS LPR Gateway Configuration Snap-inîon page 59iPrint over IPPSee ìSetup using iPrintî on page 57 andìInstall a printer with AXIS IPP Gateway Configuration Snap-inîon page 59Queue-basedprintingIPX/SPXBasicConfigurationTo install using the AXIS NetPilot Installation Wizard,see ìBasic Setup with AXIS NetPilotî on page 61IPX/SPXAdvancedconfigurationIf you need a more advanced installation that is not covered bythe AXIS NetPilot Installation Wizard, seeìAdvanced Installation using AXIS NetPilotî on page 62
