228■ When using Tajima embroidery data(.dst)b If “ON” is selected, touch and toselect the number of feed codes.The desired setting is displayed.• A value between 1 and 8 can be specified. Forexample, if 3 is specified, sequential 3 jump codeswill be converted to the trim code. But sequential 2jump codes will not be converted to the trim code, itwill be sewed as the feed (jump) stitch.Deleting short stitchesIf embroidery data other than our original patternsare used, the stitch length may be too short,possibly resulting in the thread or the needlebreaking. In order to prevent this problem fromoccurring, the machine can be set to deletestitches with a short stitch length. Stitches with alength less than that specified in this function, canbe deleted.When the embroidery machine is purchased,“0.3” was selected (delete stitches with a length of0.3 mm or less).a Touch and to select the stitch length.The desired size is displayed.• A value between 0 and 1 millimeters if the units ofmeasurements is set to “mm” (or a value between 0and 0.04 inch if the units of measurements is set to“inch”) can be specified.Specifying the remaining lengthof threadThis setting specifies whether the length of upperthread that remains threaded through the needleafter the thread is trimmed (length of thread passedthrough the eye of the needle) has a standard tailor long tail.When the embroidery machine is purchased,“Standard Tail” is selected.The setting for the remaining length of thread canbe specified from page 2 of the settings screen.a Touch and to select the setting.The desired length is displayed.• If the machine misses stitches with a standard lengthof thread after it is trimmed, select “Long Tail”.• When using metallic thread, select “Long Tail”.Note• You need to set the jump number same asthe number that was used when theparticular Tajima data was created.If the jump number is not matched, eitherunexpected trim or no trimming at trimexpected point will happen.Note• If the setting is changed from the previoussetting, the new setting is only applied tothe next embroidery.
