GETTING READY251Setup locationSet up the machine in a location that meets the following requirements.• Position the machine a minimum of 50 mm (2 inches) away from the wall• Allow sufficient space around the machine• Place no objects within the moving range of the embroidery frame• Set-up machine near an electrical outlet• Use a level and stable surface, such as a desk or stand.• Use a surface that can support the weight of the machine (about 42.5 kg (94 lb))• Allow open space around the ventilation slots found on the rear underside of the machine785 mm(31 inches)Minimum of50 mm(2 inches)589 mm(23-1/4 inches)More than350 mm(13-3/4 inches)More than210 mm(8-1/4 inches)560 mm(22 inches)More than220 mm(8-3/4 inches)CAUTION• In order to prevent malfunctions or damage, do not set up the machine in a location exposed to thefollowing conditions.Liquids, such as water Extreme dustDirect sunlightInsufficient space Blocked ventilation slotsObjects within the moving range of theembroidery frame An unstable surfaceExtremely high or extremely lowtemperatures. The operating environmentshould be between5 °C (40 °F) and 40 °C (104°F).Connection to extension cords ormultiple adaptersNote• For your safety: Since the machine weighs approximately 42.5 kg (94 lb), do not set it up on anunstable table or desk.
