26Setting up the machineWhen setting up the machine, adjust the legs sothat the machine is steady.a Make sure that all packing tape affixed tothe machine is peeled off and that allpacking material is removed.b Set up the machine while making sure thatthere is sufficient space around it.c Adjust the legs so that the machine issteady.Use the included wrench to loosen the lock nut on theleg that you wish to adjust.1 Lock nut2 Adjustable foot nut→ The foot can be turned.d Use the included wrench to turn theadjustable foot nut on the foot.Turning the nut in direction 1 lengthens the leg;turning the nut in direction 2 shortens the leg.1 Adjustable foot nut• Adjust all four legs so that they securely contact thedesk or table, and the machine is level.e After adjusting the legs to the desiredlength, use the included wrench to tightenthe nuts.1 Lock nutf Press down on each corner of theembroidery machine to check that it isstable.If it is still unstable, perform steps c through eagain to adjust the legs.Minimum of50 mm(2 inches)589 mm(23-1/4 inches)More than350 mm(13-3/4 inches)More than210 mm(8-1/4 inches)560 mm(22 inches)More than220 mm(8-3/4 inches)
