Banner ABR 7000 Series Instruction Manual

Also see for ABR 7000 Series: Quick start guide Quick start guide

Contents

Banner ABR 7000 Series Instruction Manual Manual pdf 10 page image

3 Installation Instructions3.1 HandlingProper handling ensures that the ABR will function correctly.The ABR is designed for use in an industrial environment. It is built to withstand vibration and shock when correctlyinstalled. However, it is also a precision product and before and during installation it must be handled properly to avoiddamage.• Do not drop the device (exceeding shock limits)• Do not fine tune the positioning by striking the device or the bracket• Do not weld the device into position; this can cause electrostatic, heat, or reading window damage• Do not spray paint near the reader; this can cause reading window damage3.2 Mount the ReaderNote: Mount the device at a 10° to 15° angle from the target to avoid direct reflections.1. Rotate the connector block to the desired angle.Connector blockrotates to 90˚ positionFigure 7. Connector Block2. If a bracket is needed, mount the device onto the bracket.3. Select a reading distance.The ABR 7000 manual adjustable focus models and Liquid Lens Autofocus models are both factory focused to aprecise reading distance.• If this distance is compatible with your application, or if you have a Liquid Lens Autofocus model, you canuse the Smart Teach Interface to install the reader.• If this distance is not compatible with your application and you have a manual focus model, use the softwaresetup procedure described in the Instruction Manual. SeeAdvanced Setup for Manual Adjustable FocusModels on page 46.The following table shows the Horizontal Field of View size for these factory focused reading distances:Lens Factory Focused Reading Distance Horizontal Field of View6 mm 85 mm (3.3 in) 121 mm (4.8 in)9 mm 180 mm (7.1 in) 145 mm (5.7 in)9 mm Liquid Lens Autofocus 135 mm (5.3 in)7 109 mm (4.3 in)12 mm 250 mm (9.8 in) 145 mm (5.7 in)16 mm 320 mm (12.6 in) 132 mm (5.2 in)4. Mount the device (or the device and the bracket) to the machine or equipment at the desired location. Do not tightenthe mounting screws at this time.5. Check the device alignment.6. Tighten the mounting screws to secure the device (or the device and the bracket) in the aligned position.7 SeeAim and Autofocus the Reader—Liquid Lens Autofocus Models on page 37to perform the autofocus to optimize the reader for otherdistances.ABR 7000 Series Barcode Reader10 www.bannerengineering.com - Tel: + 1 888 373 6767