4 Smart Teach InterfaceSmart Teach is designed to improve ease of installation and maintenanceStatus information is clearly presented by means of the five colored LEDs. The single push button provides access to thefollowing modes.• Test includes bar graph visualization to check static reading performance• Aim/Autofocus turns on the laser pointers to aid positioning and focusing• Setup self-optimizes and auto-configures image brightness parameters• Learn automatically detects and recognizes a single code which is presented to it. Successive Learns will substitutethe current code. To configure multiple codes, use the Barcode Manager Auto-learn procedureQuick access to the following modes is provided by using the push button:1. Press the button. The Status LED gives visual feedback.2. Hold the button until the specific mode LED is on (Test, Aim/Autofocus, Setup, or Learn).3. Release the button to enter the specific mode.After the button is pressed, the cycle of LED activation is as follows:Release button to exit Release button to enter Test mode Release button to enter Aim/AutofocusmodeRelease button to enter Setup mode Release button to enter Learn mode Release button to exit (cycle)4.1 Test ModeTest mode can be used to test the reading performance of the system. Use a code suitable for your application.1. Enter the Test function by pressing and holding the Smart Teach button until the Test LED is on.2. Release the button to enter the Test function.Once entered, the bar graph on the five LEDs is activated and if the reader starts reading codes the bar graphshows the good read rate.Figure 40. Smart Teach Interface: Test FunctionThe bar graph has the following meaning, referring to the actual percentage of good reads:≥ 20%≥ 40%≥ 60%≥ 75%≥ 95%Figure 41. Test Function Bar GraphIn case of No Read condition, only the Status LED (red) is on and blinks.ABR 7000 Series Barcode Reader36 www.bannerengineering.com - Tel: + 1 888 373 6767
