Inspection Pass/FailSelect the Contribute to Inspection Pass/Fail check box (default) if the tool will influence the Pass/Fail status of the inspection.Figure 268. Inspection Pass/FailThe Pass/Fail contribution influences the following:• Discrete output Pass• Discrete output Fail• Pass/Fail results counter• Pass (Green) and Fail (red) LEDs on the SensorSelect this checkbox if the overall Pass/Fail status of the inspection is dependent on the current tool.9.2.3 Measure Tool: Test ParametersUse the Test parameters to configure the pass/fail conditions for the tool.Select the parameter checkbox to enable it. Where applicable, the vertical green bar shows the current parameter information and thelight gray backgrounds show the range over which a value has varied over time.Figure 269. Measure Tool—Test ParametersDistanceThe straight-line distance between two constants or tools.Distance XThe x dimension vector component of the straight linedistance.Distance YThe y dimension vector component of the straight linedistance.AngleThe angle with respect to the x axis, along which thestraight line measurement vector lies. If the tool ismeasuring from one Line tool to another Line tool, theAngle is the measurement of the angle formed by the twolines. If the Force to Absolute parameter is selected, theangle is calculated relative to the reference tool thatprecedes the Measure tool.9.2.4 Measure Tool: ResultsTools & Results and All Results list information from the current and previous inspections.A red box around a tool indicates that the tool failed. Status provides information about the specific failure.All Results displays the Result, Time, Pass Count, and Fail Count information at a glance. Expand the inspection tool to see specificresults for that tool.DistanceThe straight-line distance between two constants or tools.Distance XThe x dimension vector component of the straight line distance.Distance YThe y dimension vector component of the straight line distance.AngleThe angle with respect to the x axis, along which the straight line measurement vector lies. If the tool is measuring from oneLine tool to another Line tool, the Angle is the measurement of the angle formed by the two lines. If the Force to Absoluteparameter is selected, the angle is calculated relative to the reference tool that precedes the Measure tool.Mid PointThe x and y coordinates of the middle point between the two selected points.Mid Point is calculated for point to point measurements only.VE Series Smart Camerawww.bannerengineering.com - Tel: 763.544.3164 133
