8. Use the Good Bead Width parameter under Characteristics to define the good bead width.Green indicates that the bead width is acceptable. Red indicates that the bead width is too narrow or that a gap exists. Blueindicates that the bead width is too wide.Figure 90. Good, Narrow, and Wide Adhesive Widths8.2.5 Using the Bead ToolFollow these steps to configure a Bead tool for a dark adhesive on a bright background.Note: This procedure is an example only.In this example, scaling is on (System Settings > Units > Scaling) with the Measurement Unit set at Millimeters, the Measurement inPixels set at 810, and the Measurement in Millimeters set at 70.1. Add a Bead tool to the inspection.2. Adjust the ROI path and width to match the adhesive bead.See Bead Tool: Adjust the ROI on page 61.Figure 91. Bead ROIVE Series Smart Camerawww.bannerengineering.com - Tel: 763.544.3164 63
