Inspection Pass/FailSelect the Contribute to Inspection Pass/Fail check box (default) if the tool will influence the Pass/Fail status of the inspection.Figure 280. Inspection Pass/FailThe Pass/Fail contribution influences the following:• Discrete output Pass• Discrete output Fail• Pass/Fail results counter• Pass (Green) and Fail (red) LEDs on the SensorSelect this checkbox if the overall Pass/Fail status of the inspection is dependent on the current tool.9.3.2 Logic Tool: Test ParametersUse the Test parameters to configure the pass/fail conditions for the tool. Select the parameter checkbox to enable it.Figure 281. Logic Tool—Test ParametersLogic OutputThe Boolean result for the Logic tool operation.9.3.3 Logic Tool: ResultsTools & Results and All Results list information from the current and previous inspections.A red box around a tool indicates that the tool failed. Status provides information about the specific failure.All Results displays the Result, Time, Pass Count, and Fail Count information at a glance. Expand the inspection tool to see specificresults for that tool.Logic OutputThe Boolean result for the Logic tool operation.Execution TimeThe execution time, in milliseconds, for the currently selected tool in the current inspection.Expand Execution Time to see the historical minimum and maximum execution times up to this point for the selected tool.Use the reset button in the Inspection Summary to reset these historical values.StatusStatus and error messages display as appropriate.9.3.4 Using the Logic ToolFollow these steps for an example inspection that uses the Logic tool.This example uses two Match tools and two Logic tools. The Match tools are taught independently. Each Match tool determines thepresence or absence of a different logo on different size boxes. The first Logic tool passes the inspection if either Match tool finds itsrespective logo. The second Logic tool turns on an output if a specific logo is found. This output could be used to turn on a light or tosend the box to a different line. See Using the Match Tool on page 116 for more information on using the Match tool.Note: This procedure is an example only.VE Series Smart Camera138 www.bannerengineering.com - Tel: 763.544.3164
