10. Communicator Touch Panel10. COMMUNICATOR TOUCH PANELOverview• Introduction• Installation of the touch panel interface10.1 IntroductionCommunicator Touch Panel for digital cinema projectorsThe Communicator Touch Panel is designed for multi-user command and control, the Communicator enables users to learn quicklyand operate efficiently - using an elegant and flexible touch panel interface. The interface’s commonality means that operatorscan intuitively use any model in the product line, without restriction, and its user-friendly nature translates directly into a short andenjoyable learning curve.Image 10-1Flexible touch panel interfaceThe touch panel interface can be mounted upon a swivel arm which easily fits on top of the DPxK BLP series projector. One centrallocking mechanism of the swivel arm allows an instant fixation of the touch panel interface in any position.The touch panel interface can also be installed further away from the DPxK BLP series projector. For that you can use a serial(RS232) cable up to 10 meter or an Ethernet cable up to 50 meter to allow a direct data communication between the DPxK BLP seriesprojector and the Communicator Touch Panel.The touch panel interface can also be connected with a Local Area Network (LAN) just like the DPxK BLP series projector. In thiscase both devices can communicate with each other as well.The touch panel interface requires a +12 VDC voltage, 1,5 ampere. The use of a separate +12 VDC adaptor (1,5 ampere minimum)is required.Parts location of the touch panel interfaceABC D E F G HImage 10-2Communicator touch panelR5906753 DPXK BLP SERIES 20/11/2017 113
