4. Physical installation projector4.6 Power loop through to the projector electronicsThis procedure explains how to provide the projector electronics with power in case no UPS unit is used.Note that the projector is by default configured for use without UPS. So, the short power link cable is alreadyinstalled.Necessary toolsNo tools.Necessary partsShort power link cable with plug type C13/C14How to loop through the power1. Plug in the short power cable (1) which was delivered with the projector.Warning: Always use the Barco short power cable which is delivered with the projector.123 3Image 4-14Power loop through connection2. Secure both plugs of the short cable with a fixation spring (2). Handle as follow:- Squeeze the fixation spring together.- Slide the fixation spring on the fixation pins (3) while squeezing together and push it against the power plug.- Release the fixation spring.4.7 Connecting a UPS to the projector electronicsWARNING : Only use UPS units which are suitable for the DPxK BLP series projector. See chapter ”General”,“Installation requirements” for more information about the requirements of the UPS.How to connect the UPS1. Install the UPS according to the instructions of the manufacturer and the local regulations.2. Connect the power output cord from the UPS unit to the UPS inlet socket of the projector (right socket).34 R5906753 DPXK BLP SERIES 20/11/2017
