15. Convergence2. To translate RED vertically in the Y - direction, turn both [1] and [2] anti-clockwise. Turn screws in equal increments.3. To translate RED horizontally in the X + direction, turn [3] clockwise.4. To translate RED horizontally in the X - direction, turn [3] anti-clockwise.5. For clockwise rotations of RED, turning [1] anti-clockwise would generally suffice. If much rotation is required, [2] may also beturned in the opposite direction. Slight corrections to Y may be required after rotation.6. For anti-clockwise rotations of RED, turning [1] clockwise would generally suffice. If much rotation is required, [2] may also beturned in the opposite direction. Slight corrections to Y may be required after rotation.231111RedImage 15-7Red on blue convergence15.5 Green on blue convergenceNecessary toolsNo tools.Converging the GREEN pattern onto the BLUE patternNext , align the GREEN DMD in the vertical directions [4] and [5] and then proceed with the horizontal direction [6].1. To translate GREEN vertically in the Y + direction, turn both [4] and [5] clockwise. Turn screws in equal increments.2. To translate GREEN vertically in the Y - direction, turn both [4] and [5] anti-clockwise. Turn screws in equal increments.3. For clockwise rotations of GREEN, turning [5] anti-clockwise would generally suffice. If much rotation is required, [4] may alsobe turned in the opposite direction. Slight corrections to Y may be required after rotation.4. For anti-clockwise rotations of GREEN, turning [5] clockwise would generally suffice. If much rotation is required, [4] may alsobe turned in the opposite direction. Slight corrections to Y may be required after rotation.5. To translate GREEN horizontally in the X + direction, turn [6] clockwise.6. To translate GREEN horizontally in the X - direction, turn [6] anti-clockwise.R5906753 DPXK BLP SERIES 20/11/2017 153
