2. General2. GENERALAbout this chapterRead this chapter before installing your DPxK BLP-series projector. It contains important information concerning installation re-quirements for the DPxK BLP-series projector, such as minimum and maximum allowed ambient temperature, humidity conditions,required safety area around the installed projector, required power net, etc.Furthermore, careful consideration of things such as image size, ambient light level, projector placement and type of screen to useare critical to the optimum use of the projection system.About DPxK BLP-series projectors• DP2K-36BLP• DP4K-36BLP• DP2K-23BLP• DP4K-23BLP• DP2K-17BLP• DP4K-17BLPBarco provides a guarantee relating to perfect manufacturing as part of the legally stipulated terms of guar-antee. Observing the specification mentioned in this chapter is critical for projector performance. Neglectingthis can result in loss of warranty.After unpacking let the projector acclimatizes to a room temperature higher then 10°C (50°F) and lower then35°C (95°F). It is suggests only using it after having stored it for 16 hours in final location. Neglecting this mayresult in a start up failure of the Light Processor Unit.Overview• Installation requirements• About the delivered packages• Unpacking the projector• Initial inspection2.1 Installation requirementsEnvironmental conditionsThe table below summarizes the physical environment in which the DPxK BLP series projector may be safely operated or stored.Environment Operating Non-OperatingAmbient Temperature 10°C (50°F) to 35°C (95°F) -15°C (5°F) to 60°C (140°F)Air cleanliness Clean office environment (equivalent with cleanroomstandard ISO 14644-1 ISO Class 9)n.a.Humidity 5% to 85% RH Non-condensed 5% to 95% RH Non-CondensedAltitude -60 (-197Ft) to 3000m (9843Ft) -60 (-197Ft) to 10000m (32810Ft)Let the projector acclimatize after unpacking. Neglecting this may result in a startup failure of the Light Pro-cessor Unit.Use in high altitude conditionsWhen 3000 m environmental condition is combined with the highest permissible temperature (35°C ambient), the projector may beexpected to go into warning status. Hence, for high altitude conditions, we advise max 30°C ambient condition (25°C is preferred).Furthermore, to avoid temperature warnings on laser banks, we advise in high altitude to set cooler fans to 100%.R5906753 DPXK BLP SERIES 20/11/2017 15
