8. Input & communication8.3 Integrated Cinema Processor (ICP)In case the projector is equipped with a Barco ICMP no ICP board is inserted. All ICP functionality is integratedin the Barco ICMP.LEDs and ports on the Integrated Cinema ProcessorUSBOUTUSBINICPPOWERSWSTATOSSTATFMTSTATICPSTAT CINEMAALTCONT1 23456 7 8 9Image 8-31 ICP is powered.2 ICP software state, normal operation is green blinking.3 ICP operating system state, normally full green .4 ICP FMT configuration state, normally full green.5 ICP MAIN configuration state, normally full green.6 CINEMA port selected. When on, LED 7 will be out.7 ALTERNATIVE port selection. When on, LED 6 will be out. (note that this function is disabled. Led never lights up)8 USB, for future use.9 USB, for future use.LED diagnosticState description Normal operation Error stateSoftware state (LED reference 2) flashing green red or orangeOperating System state (LED reference 3) green off, red or yellowFMT FPGA state (LED reference 4) green red : unable to configure the FPGAyellow : FPGA is loaded with the BootapplicationICP FPGA state (LED reference 5) green red : unable to configure the FPGAyellow : FPGA is loaded with the BootapplicationICP functions:• Stores all projector files. When board is replaced; clone package must be reloaded.• Stores and generates test patterns.• Scaling to native resolution, re-sizing, masking, line-insertion de-interlacing, subtitle overlay, color space conversion,de-gamma, color correction• Source Selection between alternative content and cinema content.• Stores a Certificate and Private Key needed for Playback validation• Contains a real time clock, which must be synchronized with the GMT/UTC time stored in the link decryptor module or IntegratedMedia Block (see Communicator software)• Handles unpacking of special video formatsThe ICP board spare part kit is not default programmed for a DPxK BLP series projector projector. When usingthis board in a DPxK BLP series projector projector the software must be re-installed after installation of theboard.When installing a new ICP board in a DPxK BLP series projector projector the Spatial Color Calibration filemust be reloaded and activated.C AUTION : Make sure not to short circuit the battery on the board. That will destroy the board completely !R5906753 DPXK BLP SERIES 20/11/2017 81
