4. Physical installation projector4. PHYSICAL INSTALLATION PROJECTORAbout this chapterThis chapter describes how the set up of the projector has to be done.Overview• Positioning the DPxK BLP series projector at port window• Access to the power connection• Power input setup of the DPxK-36BLP• Connecting the DPxK-17/23BLP with the power net• Connecting the DPxK-36BLP with the power net• Power loop through to the projector electronics• Connecting a UPS to the projector electronics4.1 Positioning the DPxK BLP series projector at port windowWARNING : The installation of the DPxK BLP series projector requires at least 4 persons.General guide lines• Use a solid pedestal to put the DPxK BLP series projector on. Ensure that the pedestal can handle the weight of the projectorand that all feet of the projector are captured.• The pedestal should be placed in front of the port window wall in a manner that the projector front cover is at a minimum distanceof 20 centimeters from the port window.20 cmImage 4-1Positioning at port windowBarco offers a pedestal for the DPxK BLP-series projector. This universal pedestal allows a solid and easysetup of the projector. The universal pedestal has a separate compartment to install the UPS unit (if available)for the DPxK BLP-series projector. Futhermore, the universal pedestal contains a standard 19” rack to buildin the projector peripherals like alternative content switchers.Necessary tools• 14 mm wrench• 17 mm wrenchProjector centering1. If the projector is standalone in front of the port window, center the projector with the theatre screen (see ref A image 4-2).R5906753 DPXK BLP SERIES 20/11/2017 27
