Barco R9002380 Owner's Manual

Contents

Barco R9002380 Owner's Manual Manual pdf 26 page image

Getting Started3-6 5976066 BARCOCINE 7 011299Before using the RCUThe RCU is default programmed with address 0 or 1, 'common address'. Regarding to the internal wiring of the RCU the default addresscan be 0 or 1 (call for technical assistance to change the common address setting). With that 'common address' programmed intothe RCU, every projector, without exception will listen to the commands given by this RCU. If it is necessary to control a specificprojector, than enter the projector address into the RCU (only when that address is between 0 and 9). The projector with thecorresponding address will listen to that specific RCU.Common AddressEvery projector has a common address '0' or '1'. The choice between '0' and '1' can be selected in the Service mode.Display the Projector Address on the Screen.Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's address will be displayed in a 'Text box' (menu 1).This text box disappears after a few seconds.PROJECTOR ADDRESS001To continue using the RCU with that specific address, it is necessary to enter the same address with the digit buttons (address between0 and 9) within 5 seconds after pushing the address key. For example : if the Address key displays projector address 003, then press"3" digit button on the RCU to set the RCU's address to match the projector's address. Do not press 003 digits. This will address theremote control to '0' and control all projectors in the room.If the address is not entered within 5 seconds, the RCU returns to its default address (zero address) and control all projectors in theroom.How to program an address into the RCU?Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address with the digit buttons within 5 seconds afterpushing the address key. That address can be any digit between 0 and 9.Controling the ProjectorInput selection modesSource No Projector input Press button1 Comp. Video 12 S-Video 23 RGBS or RGsB 33 RGB3S or RG3sB 43 (R-Y)Y(B-Y)S or(R-Y)Ys(B-Y) 53 (R-Y)Y(B-Y)3S or(R-Y)Y3s(B-Y) 6Input Selection via the RCU.With the digit buttons on the RCU, it is possible to select one of the above input modes.