General Configuration Screen2H22-08R SmartSwitch 2208 User’s GuidePage 5-25If the time entered is a valid format, the message displays “SAVED OK”at the top of the screen. If the entry is not valid, Local Management doesnot alter the current value and refreshes the Device Time field with theprevious value.5.7.7 Entering a New Screen Refresh TimeThe screen refresh time is set between 3 and 99 seconds with a default of3 seconds. To set a new screen refresh time, perform the following steps:1. Use the arrow keys to highlight the Screen Refresh Time field.2. Enter a number from 3 to 99.3. Press ENTER to set the refresh time to the time entered in the inputfield.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is within the 3 to 99 seconds range, the message“SAVED OK” displays at the top of the screen. If the entry is not valid,Local Management does not alter the current setting, but it does refreshthe Screen Refresh Time field with the previous value.5.7.8 Setting the Screen Lockout TimeThe screen lockout time is set between 1 and 30 minutes with a default of15 minutes. To set a new lockout time, perform the following steps:1. Use the arrow keys to highlight the Screen Lockout Time field.2. Enter a number from 1 to 30.3. Press ENTER to set the lockout time in the input field.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is within the 1 to 30 minute range, the message“SAVED OK” displays at the top of the screen. If the entry is not valid,Local Management does not alter the current setting, but it does refreshthe Screen Lockout Time field with the previous value.
