System Resources Screen2H22-08R SmartSwitch 2208 User’s GuidePage 5-51Flash Memory Installed (Read-only)Indicates the amount of FLASH memory installed in the 2H22-08R andhow much is currently available.DRAM Installed (Read-only)Indicates the amount of DRAM installed in the 2H22-08R and how muchis currently available.NVRAM Installed (Read-only)Indicates the amount of NVRAM installed in the 2H22-08R and howmuch of it is currently available.Current Switch Utilization (Read-only)Shows the percentage of the device’s switching capacity currently beingused.Peak Switch Utilization (Read-only)Shows the peak percentage of device’s switching capacity used, since thelast reset.Reset Peak Switch Utilization (Toggle)Allows you to reset the Peak Switch Utilization field. The switch may beset to either YES or NO as described in Section 5.13.1. YES resets thePeak Switch Utilization field to the current system traffic.5.13.1 Setting the Reset Peak UtilizationTo set the Reset Peak Utilization field to YES or NO, proceed as follows:1. Use the arrow keys to highlight the Reset Peak Switch Utilizationfield.2. Press the SPACE bar to select YES or NO.3. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen.4. Press ENTER. The message “SAVED OK” displays.
