Cabletron Systems 5000, 5500 Manual

Contents

Device Application ViewCatalyst Filter TablesApplication View Cisco Catalyst 5000/5500 Hub5-12 Management Module GuideTypeDisplays the type of action this filter will cause. Selecting Invalid removes thisfilter from the table. Selecting Deny causes packets whose Type field or DSAP/SSAP field matches the value specified in the Value field to be dropped.Selecting Permit causes all packets whose Type field or DSAP/SSAP field doesnot match the value specified in the Value field to be dropped.Test TableThe Test Table contains a list of test filter entries. Double-click a table entry toaccess an entry-specific Filter Test Table view that allows you to modify theinformation presented in the table. The Test Table and its correspondingentry-specific views provide the following information:ModuleDisplays the unique integer identifier of the module where this port is located.This number is the same as the slot number in which the module is installed.PortDisplays the unique integer identifier of this port within its module. Thisvalue is determined by the location of the port on the module.IndexDisplays an index value that uniquely identifies a test for a particular moduleand port (Test Table only).TypeValidates or shows a new module, port, or test index (when one exists).OffsetDisplays a byte offset into a packet. Must be a 32-bit word aligned offset, i.e.,0, 4, 8, etc.ValueA 32-bit value to be compared against the packet location specified in theOffset field (Entry-specific view only).MaskAn internet mask the server uses to distinguish internet address that can bereached directly from those that must be reached via an IP gateway.Port TableThe Port Table contains a list of port filter entries. Double-click a table entryto access an entry-specific Filter Port Table view that allows you to modify theinformation presented in the table. The Port Table and its correspondingentry-specific views provide the following information: