Cabletron Systems Cyber SWITCH 1000 User Manual

Cabletron Systems Cyber SWITCH 1000 User Manual Manual pdf 51 page image

Workgroup Remote Access Switch 51IP R OUTING NETWORK WITH R EMOTE B RIDGE DEVICESConfigure the CyberSWITCHC ONFIGURE THE C YBER SWITCHUsing the detailed instructions found in the Simple Remote Bridging chapter, complete theconfiguration steps listed below.Note: The software should have already been installed and the system prompt should bedisplayed before beginning the configuration.Start the CFGEDIT programSelect physical resourcesSelect to add a resourceSelect Switch type to be NI-1Select to add a lineSelect slot 1, port 1Enter “Line1” as the line nameAdd Data LinksChoose Auto TEI NegotiationEnter SPID ValueEnter Directory Number for Data LinkEnter Maximum Number of Digits to VerifyRepeat “Add Data Links” for second Data LinkRepeat “Select to add a line” for each additional lineThe following sections provide instructions for completing the remaining configuration steps.CONFIGURING THE CYBER SWITCH OPTIONSTo begin the configuration of the system options, press 2 at the Main Menu. The options menu willthen be displayed.E NABLE /D ISABLE B RIDGINGWhether or not to use bridging depends on network requirements. The RLAN interface will workeither way. For this example, we will assume that we only want to route IP traffic onto the corporateLAN. Therefore, we will disable bridging on the CyberSWITCH. IP routing is already enabled asfault, so no change is necessary.For this example, the only other IP information we need to configure is two IP interfaces. (No staticroutes are needed.) The next section will provide the instructions needed to configure the necessaryIP interfaces.C ONFIGURING THE IP I NTERFACE I NFORMATIONIn our example, we need to configure two types of interfaces. The LAN interface represents thesystem connection to the LAN IP Network 128.1.0.0. The WAN RLAN interface represents thesystem connection to the remote IP network 198.12.10.0.Press 2 at the IP main menu to begin the configuration of the IP interface information. Press 1 toadd an IP interface. Select the LAN interface option from the list of possible interface types.