Cabletron Systems Cyber SWITCH 1000 User Manual

Cabletron Systems Cyber SWITCH 1000 User Manual Manual pdf 58 page image

IP R OUTING NETWORK WITH PPP DEVICESOVERVIEWThis sample network uses IP routing to connect two of our products, both using PPP. Each systemis on a separate LAN. The configuration for this network is designed to allow three different typesof accesses:• To give Host1 access to resources on LAN2, and to give Host2 access to resources on LAN1.• To give Host2 access to the Internet which is connected to LAN1.• To allow Host1 to remotely manage SITE2, and to allow Host2 to remotely manage SITE1.These accesses are achieved through configuring a combination of interfaces and static routes.To better understand the layout of this network, refer to the CyberSWITCH Network TopologyWorksheet.This chapter discusses the configuration process for SITE1 and SITE2. Note that the NetworkTopology and the System Details worksheets are identical for both systems. Each system hasunique Routing Information and Device Information worksheets.INITIAL I NSTALLATION STEPSThe initial steps in the CyberSWITCH installation process are basically the same no matter howcomplicated the network. These steps are:• completing the requirement worksheets• ordering ISDN service• powering on the system• accessing Release Notes• connecting an administration console• setting up Telnet access• upgrading system software• changing defaults to secure system• returning configuration to factory defaultsThe chapters Accessing the CyberSWITCH and Upgrading System Software (in the User’s Guide)describe each of these steps in detail.Worksheets for this network are included on the next few pages.