Workgroup Remote Access Switch 65IP ROUTING N ETWORK WITH PPP DEVICESConfigure SITE1C ONFIGURE SITE1Note: The software should have already been installed and the system prompt should bedisplayed before beginning the configuration.Using the detailed instructions for these steps found in the Simple Remote Bridging chapter,complete the following configuration steps.Start the CFGEDIT programSelect physical resourcesSelect Switch type to be 5ESSSelect to add a lineEnter the line nameSelect slot and port numbersSelect line interface type of “Point-to-Point”Add Data LinksChoose Auto TEI NegotiationRepeat “Select to add a line” for each additional lineThe sections below provide instructions for completing the remaining configuration steps for SITE1and SITE2.CONFIGURING THE S YSTEM O PTIONSTo begin the option configuration, press 2 at the Main Menu. The options menu will then bedisplayed.For this example, we only need IP routing enabled. The first thing to do: disable bridging. Afterthat, we will need to enable IP routing, and configure all the necessary IP routing information. Todisable bridging, press 1 at the Options Menu. Follow the onscreen prompts to disable bridging.Press to return to the Options Menu.E NABLING THE INTERNET PROTOCOL (IP R OUTING )To enable IP routing and configure all the necessary IP routing information, press 2 at the OptionsMenu. The abbreviated IP Configuration Menu will then be displayed.The next step is to enable the Internet Protocol (IP routing). Press 1, and follow the onscreeninstructions for enabling IP routing. The complete IP routing menu will then be displayed.For this example, the additional IP information we need to configure is IP interfaces and a staticroute. The next two section will provide the instructions needed to configure this IP information.