Cabletron Systems CyberSWITCH CSX1000 Quick Start Manual

Also see for CyberSWITCH CSX1000: User guide User guide

Contents

QUICK START20 CyberSWITCH5. Under Security, select System Options and Information, then under System Information:a. Set your System Name (Central). This matches up with Central device informationconfigured on Remote.b. Set your System Secret (Central_S). This matches up with Central device informationconfigured on Remote.6. Under Security, select Device Level Databases, select On-node Device Entries, then add a devicewhere the Device Name (Remote) must match the system name on Remote. When you add thedevice you must then enter the following information:a. Under ISDN Information select ISDN Line Protocol, then select PPP.b. Optional: If you wish to dial out to Remote, under ISDN Information, enter a dial outnumber (13135552222) and a base data rate (64Kb).c. Under Authentication you must:• Change CHAP Secret so that it matches Remote’s System secret (Remote_S).• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).d. Under Bridge Information you must:• Make sure that Bridging is enabled• Optional: If you wish to dial out to Remote you must enable Make calls for Bridge Data.5. Optional: If you wish to dial out to Remote you have to specify the method that you will usedetermine how to make bridge dial out calls. The two methods, and how to configure them arelisted below:a. Select Options from the main menu, then the bridging menu, and from the bridging menuselect bridge filters. Set up a Bridge filter with connect as the action. For some filter typesyou will need to specify Remote as the device.b. Select Options from the main menu, then the bridging menu, and from the bridging menuselect Known Connect List, then enter the name of the Device (Remote) that you wish to callif a packet is received whose MAC address is known to be at the location that wasconnected earlier by the User’s device.For a more detailed description of each of the above methods, refer to the Installation Guide’schapter titled Configuring Advanced Bridging.C ONFIGURATION FOR S ITE "REMOTE"The configuration on Remote so that it may use bridging to Central using PPP is as follows:1. Perform initial configuration steps.2. Under Options, select Bridging and make sure that it is enabled. Also, select IP routing anddisable IP routing to allow timely bridging of IP data.3. Under Security, select System Options and Information, then under System Information:a. Set your System Name (Remote). This matches up with Remote device informationconfigured on Central.b. Set your System Secret (Remote_S). This matches up with Remote device informationconfigured on Central.