Cabletron Systems CyberSWITCH CSX1000 Quick Start Manual

Also see for CyberSWITCH CSX1000: User guide User guide

Contents

QUICK START24 CyberSWITCHc. Under Authentication you must:• Change CHAP Secret so that it matches Remote’s System secret (Remote_S).• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).d. Under IPX Information:• enable IPX• enable Make Calls for IPX data• enable IPXWAN protocol• select Triggered RIP/SAP with a WAN peer type of ACTIVE from the Routing ProtocoloptionNote: By using triggered RIP/SAP, you do not need to configure static routes or services.C ONFIGURATION FOR SITE "REMOTE"The configuration on Remote to allow IPX Routing to Central using PPP is as follows:1. Perform initial configuration steps.2. Under Options, select IPX Routing, then:a. Enable IPX Routing.b. Under IPX Internal Network Number enter the following value: 456789.c. Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number(33333333).3. Under Security, select System Options and Information, then under System Information:a. Set your System Name (Remote). This matches up with Remote device informationconfigured on Central.b. Set your System Secret (Remote_S). This matches up with Remote device informationconfigured on Central.4. Under Security, select Device Level Databases, select On-node Device Entries, then add a devicewhere the Device Name (Central) must match the system name on Central. When you add thedevice you must then enter the following information:a. Under ISDN Information select ISDN Line Protocol then select PPP.b. Under ISDN Information you must enter a dial out number (13135551111) and a base datarate (64Kb) to dial out to Central.c. Under Authentication you must:• Change CHAP Secret so that it matches Central’s System secret (Central_S).• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).d. Under IPX Information:• enable IPX• enable Make Calls for IPX data• enable IPXWAN protocol• select Triggered RIP/SAP with a WAN peer type of ACTIVE from the Routing Protocoloption.Note: By using triggered RIP/SAP, you do not need to configure static routes or services.