Workgroup Remote Access Switch 25C ONNECTIVITYConnecting a Workgroup Product to a Small Office Product via PPPAPPLE TALK ROUTER TO APPLET ALK ROUTER CONFIGURATIONC ONFIGURATION FOR S ITE "CENTRAL"The configuration on Central to allow AppleTalk Routing to Remote is as follows:1. Perform initial configuration steps.2. Under Security, select Device Level Databases, select On-node Device Entries, then add a devicewhere the Device Name (Remote) must match the system name on Remote. When you add thedevice you must then enter the following information:a. Under ISDN Information select ISDN Line Protocol, then select PPP.b. Optional: If you wish to dial out to Remote, under ISDN Information you must enter a dialout number and a base data rate (64Kb).c. Under Authentication you must:• Change CHAP Secret so that it matches Remote’s System secret (Remote_S).• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).d. Under AppleTalk Information you must:• Enter 0.0 for the AppleTalk address.• Enable AppleTalk Routing.• Enable making calls for AppleTalk data.3. Under Options, select AppleTalk Routing, then:a. Enable AppleTalk routing.b. Under AppleTalk Port Information, configure a LAN port:• Select the LAN port type.• Enter lanport1 for the port name.• Enter 1 for the LAN port number.• Select the Extended network type (the default).• Enter 10-13 for the network range.• Accept the default of none for the suggested AppleTalk address.• Enter Engineering as the port’s default zone name.• Enter Marketing as the second zone name.Central's AppleTalk ConfigurationNetwork Range: 10-13Zones:Central.Engineering (default)Central.MarketingRemote's AppleTalk ConfigurationNetwork Range: 45-50Zones:Remote.Engineering (default)Remote.MarketingCSX1200 CSX150MAC MAC MAC MACISDN"Remote""Central" POWER SERVICE TX RX 10BASE - TLAN B-CHANNELS E1 ONLYB2 B4 B6 B8 B26 B28B22 B24B18 B20B14 B16B10 B12 B30 L1B1 B3 B5 B7 B25 B27B21 B23B17 B19B13 B15B9 B11 B29 B31E1D T1D