ESTABLISHING COMMUNITY NAMESEMM-E6 User’s Guide6-36.3 ESTABLISHING COMMUNITY NAMESIn order for any Community Name Table edits to take effect, you musthave super-user access. In other words, when you log into LM, you mustdo so with a super-user password. A password from any of the other levelsof access (basic-read, read-only, or read-write) does not allow you to editthe Community Name Table Screen.Establishing community names:1. Use the arrow keys to highlight the Community Name field adjacentto the access level of your choice.2. Enter the name into the field (maximum 32 characters).3. Press the Return key.4. Repeat steps 1 - 3 to modify any other community names.5. Use the arrow keys to highlight the Save command at the bottom of thescreen and press the Return key. The message “SAVED OK” appears.The EMM-E6 saves the community names in memory, andimplements their access modes.If you exit without saving, a “NOT SAVED?” message appears abovethe SAVE command. If you proceed to exit without saving, you loseall edits.6. To exit the screen use the arrow keys to highlight Return and thenpress the Return key. The Feature Selection Screen appears.Any community name assigned in the Community Name Tableis a password to its corresponding level of LM access. Thesenames are case sensitive. The community name assignedsuper-user access is the only one that gives you completeaccess to LM. Remember this name.NOTE
