EMM-E6 QUICK REFERENCE CARDEMM-E6 QUICK REFERENCE CARD• Slide the EMM-E6 into the first and second slots of the MMAC chassis (asshown below).• Secure the module by tightening the knurled knobs at the top and bottom ofthe module.• Power on the MMAC chassis. Monitor the state of the CPU LED.• The CPU LED will flash, indicating the EMM-E6 is in boot state. During thisperiod, which may last up to 5 minutes, the STBY LEDs will blink to indicatethe module’s boot state.• Fully operational EMM-E6 should display the following LED states:- CPU LED flashing, indicating normal operation.- STBY LEDs lit or unlit, depending on the results ofspanning tree operation.- Appropriate BRIM/EPIM LEDs lit.- ON LED lit for the active Channel D EPIM.Use the following setup parameters for a VT Terminal or Terminal Emulationpackage to connect to Local Management functions.Columns: 80 Columns Controls: InterpretControls Autowrap: No AutowrapScroll: Jump Scroll Text Cursor: Cursor Cursor Style: UnderlineMode: VT300, 7 Bit ID Number: VT320 orVT100 Cursor Keys: NormalTransmit: 9600 Receive: 9600 XOFF: XOFF at 64Bits: 8 Bits Parity: No Parity Stop Bit: 1 Stop BitLocal Echo: No LocalEcho Port: DEC-423 AutoAnswerback:No AutoAnswerbackKeys: TypewriterKeys Margin Bell: Margin Bell WarningBell: Warning BellEMM-E6INSTALLATIONTERMINAL SETUP
