CHAPTER 7: CONFIGURATION SCREEN7-2EMM-E6 User’s Guide7.2 CONFIGURATION SCREEN FIELDSThe following briefly explains each Configuration Screen field.I/FDisplays the interface number (1 to 6) corresponding to a particularEMM-E6 channel. This number allows the EMM-E6 to accuratelyidentify MIB II channel information. The following table illustrates theI/F number to channel association.Channel A is the original Ethernet bus channel. Channels B & C are theFlexible Network Bus (FNB) channels. Channel D is an external Ethernetnetwork accessed through an Ethernet Port Interface Module (EPIM).Channels E and F are external connections through optional BRIMs.Refer to Chapter 1 of this User’s Guide for a more complete descriptionof channels.IP AddressDisplays the IP address for each interface of the EMM-E6. This IPaddress will be used for the sending and receiving of SNMP data andshould be configured for the interface with a connection to the networkmanagement station. If the network management station is located on adifferent network or subnet, the Default Interface and Default Gatewaymust be properly configured to allow the proper functioning of SNMPmanagement.I/F Channel1 A2 B3 C4 D5 E6 FChannel E and F configuration options are dynamic. Thismeans the EMM-E6 only provides options for Channels E orF if you have a BRIM module installed in one of these slots.NOTE
