Configuration View DescriptionConfigure Alarms ViewConfiguration Views Cabletron Ethernet Hubs4-10 Management Module GuideError ThresholdThe threshold value within the alarm timebase which, once the percentage oferrors per good packet is exceeded, generates an error alarm. This field is notavailable in the MRXI Configure Alarms View.This button allows you to Enable or Disable detection of Broadcast Alarms.This button is available only in the IRM2 and IRM3 Configure Alarms Views.Broadcast ThresholdThe threshold value within the alarm timebase which, once that number ofbroadcasts received is exceeded, generates a broadcast alarm. This field isavailable only in the IRM2 and IRM3 Configure Alarms Views.Time BaseThe number of seconds used as the interval for performing all of the ratealarm checks. The minimum is 10 seconds. For example, if the time base is 10seconds, an alarm will occur only when the specified number of errors occurswithin 10 seconds.This button allows you to Enable or Disable the audible alarm in the hub. Youmust have a community name with Read/Write permission to update thisfeature. This button is available only in the IRM2 and IRM3 Configure AlarmsViews.This button permits a management station to turn off a sounding alarm.Attempting to change this button to the ON position may result in a writefailure error. You must have a community name with Read/Write permissionto update this feature. This button is available only in the IRM2 and IRM3Configure Alarms Views.Broadcast AlarmsAudible AlarmSound Audible Alarm