Cabletron Systems Ethernet Hubs Manual

Contents

Configuration View DescriptionRedundancy ViewConfiguration Views Cabletron Ethernet Hubs4-12 Management Module GuideThis button allows you to test the redundant circuit.Test Time of DayThe time of day at which the redundant circuits should be tested. This field isnot available in the MRXI Redundancy View.This button allows you to display the MMAC Redundancy Table. TheRedundancy Table allows you to set up redundant circuit connections betweenany two or more hubs that have redundant capability in their firmware. Formore information on setting up redundant circuits, refer to Hub RedundancyManagement in this chapter.You can double-click on any of the circuit names in the Redundancy Table toaccess the MMAC Redundancy Information View. This view lets you set upredundancy circuits. Table 4-3 provides the information contained in the view.Test Redundant CircuitsRedundancy TableTable 4-3. MMAC Redundancy Information View FieldsField DefinitionCircuit Name The name of the indicated circuit.Retry Count The number of unanswered polls allowed for theindicated circuit before the current connection isdeclared bad.Bd/Port Combination The number of board/port combinations associatedwith the indicated circuit.MAC Address Add(IRM2, MRXI,MiniMMAC)Adds the Ethernet address to the polling list for theindicated circuit.IP Address Add (IRM3) Adds the IP address to the polling list for the indicatedcircuit.Number of Addresses The number of addresses associated with the indicatedcircuit.Circuit Enable Enables or disables the indicated circuit.Circuit Number The number from the circuit names in the Redundancytable (e.g., Circuit 04).Board Port Instance The board number and port number that theredundant circuit is connected to. For example, 3.6 isboard 3, port 6.Port Circuit Status The current state of this port in the redundant circuit.Port Circuit Type The type of port this port is in the redundant circuit.