8-30 FRX4000/FRX6000 4.0 User Guide, Rev 01Translation Template Parameters1 Used simply for ease of identification.2 These determine the translation formula:P = Pass through unchanged.R = Remove entire field.L = Replace with literal digit.X = Replace with original called address.G = Replace with original calling address.U = Replace with original user data.T = Replace with ASCII text.If replacing all or part of a field, see "Replacing (field type)" over the next few pages.All wild cards are valid in the translation template, allowing one template to functionfor many calls.The FRX4000/6000 routes traffic based on the user data field if the U operator ispresent in the SVC routing table. The gateway also allows the U operator, and caninclude user data field operations.Replacing Called/Calling Address or User DataTo replace all or part of any of these fields, press [B] or [C] at the Translation TemplateMaintenance Menu. When prompted, enter the desired information as describedbelow:L = Literal digits, which means that the actual digits you enter here will replace thatsame number of digits in the specified field. Type L followed (with no spaces) bythe desired digits, 0–9. For example, typing L1234 [Enter] will replace four digitsin the selected part of the field with the actual numbers 1234.X = Called address. The characters entered here are not necessarily the exact char-acters of original called address, but rather the characters (digits or wildcards) ofthe template ID that match the original called address (that part not already trans-lated).Type X followed (with no spaces) by the desired characters, 1–9, A–F, indicatingwhich positions of the 15 digits in the original called address are to replace theselected portion of the packet. For example, typing X1234 [Enter] takes the first,second, third, and fourth characters of the (remaining) original called address partof the template ID.Table 8-7 Translation Template ParametersParameter Valid Values Default ValueTemplate Name 1 0–31 characters noneCalled Address P,R,L,X,G,U 2 PCalling Address P,R,L,X,G,U 2 PUser Data P,R,L,X,G,U,T 2 PProtocol ID P ,0–8 characters 2 PFacilities P ,R,0–218 characters 2 P
