5-10 FRX4000/FRX6000 4.0 User Guide, Rev 01FRX6000 RLP Parameters1 T1 and E1 LICs are supported only on the 8-MB RLP.2 The size of each protocol and the amount of RLP memory determine the combinationsof protocols that can be configured on an RLP. (See explanation.)3 Selecting this parameter changes the value to the next one in this list:0–133 ft. (0 dB), 133–266 ft., 266–399 ft., 399–533 ft., 533–655 ft., minus 7.5 dB, minus15 dB, minus 22.5 dB.4 Displayed only if CRC-4 Disabled is N.5 Displayed only if Chnl Signaling is Associated.Table 5-3 FRX6000 RLP ParametersParameter Valid Values Default ValueRLP Type None, RLP NoneLine Interface Card 1, 2 None, RS-232, RS-422, V.35, T1-DSX1,E1-75ohm, T1-RFU, E1-120ohm 1 NoneProtocol "n" None, X.25, Frame Relay, Async,SDLC, BSC-I, BSC-B, IP, SNMP, RIP,LLC2, IPX, NVSP, BRIDGEnext in list not alreadyconfigured, among theones that will fit 2T1 LIC ParametersLine Coding B8ZS/AMI B8ZSFraming ESF, D4 ESFLine Service Full, Fractional FullLine Build Out see footnote 3 0–133 ft. (0 dB)Clocking Master, Slave SlaveBase Chl Speed 56K, 64K 64KStarting Chl Number If Line Service = Fractional: 1–24If Line Service = Full: n/a1 (only if Line Ser-vice = Fractional)Num of Chnls If Line Service = Fractional: 1–24If Line Service = Full: n/a24 (only if Line Ser-vice = Fractional)E1 LIC ParametersLine Coding HDB3 HDB3Framing G.704 G.704Line Service Full, Fractional FullLine Build Out G.703 G.703Clocking Master, Slave SlaveBase Chl Speed 64K 64KStarting Chl Number If Line Service = Fractional: 1–30If Line Service = Full: n/a1 (only if Line Ser-vice = Fractional)Num of Chnls If Line Service = Fractional: 1–30If Line Service = Full: n/a30 (only if Line Ser-vice = Fractional)CRC-4 Disabled Y/N NChnl Signalling Common, Associated CommonNtnl Use Bit "n" On, Off OffIntNtnl Use Bit 0, 1 4 On, Off OnCAS X1/2/3 Bit On, Off OffCAS A/B/C/D Bit 5 On, Off Off
