Configuring Frame Relay 7-9Configuring Frame Relay PortsOnce the necessary Node and RLP parameters have been configured, press [A] at thePort Configuration Menu (or [A], [C], [A] from the Main Menu. When prompted, enter:l (FRX6000 only) RLP containing the port: 0–7. (The default is 0.)(RLP numbers are described in Chapter 5.)l Port (see port locations in Chapter 6): 0–7. (The default is 0.)The display for an existing port will show the configured parameter values, while thedisplay for a new port will show default database values. (See Table 7-3 and Table 7-4.) The following figure is an example of an existing port.Figure 7-3 Frame Relay Port Screen 1[A],[C],[A] from Main MenuThe above is an example of an existing frame relay port. On an FRX4000with Physical Port Interface (item B) configured as DSU, items G and H will bedifferent.After making any changes, be sure to press [F7] to update thesystem memory. Otherwise, the changes will not take effect untilthe next re-boot of the FRX4000/6000.Pressing [O] will display a screen similar to the following.Node Name=node_xyzFrame Relay Port Parameters (screen 1 of 2)* RLP: 0 Port: 0 Link State: Linkup* I/O: V.35Database System MemoryA Port Type Frame Relay Frame RelayB Physical Port Interface V.35 V.35C Blocked Port Flag N ND Line Speed 64K bps 64K bpsE Maximum Bytes per Frame 1600 1600F Logical DCE N NG Generate Clock N NH Rcv Clock (TT) from DTE N NI Link Management 2 Annex D 2 Annex DJ N1 Polling Count 6 6K N2 Error Threshold 3 3L N3 Monitored Events Count 4 4M T1 Link Integrity Timer 10 10N T2 Polling Verification Timer 15 15O Additional ParametersOption:
