13-8 FRX4000/FRX6000 4.0 User Guide, Rev 01IP Interface ParametersTable 13-2 through Table 13-4 list all possible IP Interface parameters. (Some will notbe displayed, depending on how others are configured.) Because several parametersapply to more then one interface type, descriptions of all IP Interface parametersfollow Table 13-4.1 Make sure the frame relay port is not configured (in the Port record) for backup use only.2 Make sure the DLCI is not part of a frame relay DLCI backup group or intra-nodal framerelay PVC.3 Y for new interfaces, N for interfaces already configured when the current release ofFRX4000/6000 software is installed.4 255.255.255.255 is valid only on a point-to-point interface.5 See the caution following these footnotes. The default value of Network Mask will beconfigured automatically, to reflect the appropriate address class, after the Source IPAddress is specified. If the interface is configured as unnumbered (and, therefore, noSource IP Address is configured), the default value of Network Mask will be taken fromthe numbered interface that is assigned.If a Source IP Address is specified/changed, the Network Maskwill automatically change to a default value appropriatefor the new address. For this reason, configure the SourceIP Address first, then the Network Mask.Table 13-2 Frame Relay IP Interface ParametersParameter Valid Values Default ValueMaximum Transmission Unit 1–4096 1500Routing Metric Count 0–255 0ICMP Redirects Y/N YRIP Support 0 (Enabled), 1 (Rcv only),2 (Disabled) 0 (Enabled)RIP Flash Updates (sec) 5–300 10RIP Full Updates (sec) 10–300 30Priority 0–9 5Bandwidth Allocation Group 1–16 1Interface Type FRL (frame relay) FRLSource Card (FRX6000 only) 0–7 0Source Port 0–7 1 0Source DLCI 16–991 2 16Enable Inverse ARP Y/N see note 3Destination IP Address 1.0.0.0–223.255.255.255 noneUnnumbered Interface Y/N see note 3Source IP Address 1.0.0.0–223.255.255.255 noneNetwork Mask 255.0.0.0–255.255.255.255 4 255.0.0.0 5
