Cabletron Systems Netlink FRX4000 User Manual

Also see for Netlink FRX4000: User guide Installation & setup guide User guide Reference guide Installation and setup guide

Contents

Cabletron Systems Netlink FRX4000 User Manual Manual pdf 68 page image

5-6 FRX4000/FRX6000 4.0 User Guide, Rev 01Ntnl Use Bit "n"is the setting of the national use bits in the non-frame alignment signal. National usebits 1-5 correspond to data bits 4-8 in the non-frame alignment signal. National usebits are reserved for use within a country. If the signal will cross an internationalborder, the national use bits should be Off.IntNtnl Use Bit 0is the setting of bit 0, which is transmitted as the most significant bit of the framealignment signal when CRC-4 is disabled.IntNtnl Use Bit 1is the setting of bit 1, which is transmitted as the most significant bit of the non-framealignment signal when CRC-4 is disabled.CAS X1/2/3 Bitdetermines whether spare bits X1, X2, and/or X3 will be used.CAS A/B/C/D Bitdetermines whether signaling bits A, B, C, and/or D will be used in timeslot 16 whenChnl (Channel) Signaling is Associated.LAN PortEach FRX4000 contains a LAN port, either Ethernet or Token Ring (depending on themodel). To configure the port, press [B] at the Port Configuration Menu.Figure 5-3 LAN Port Configuration Record[A],[C],[B] from Main MenuItem C (Ring Speed) will not be displayed if Type is Ethernet.Node Name=nodexyzLAN Card Configuration* Interface Number: 0* Type Token RingB Locally Admin MAC Addr 400000000001C Ring Speed 16 MBits/secOption: