Configuring SNA 9-15addresses are valid only if Y is specified for one or more of items C, D, and E on thefirst screen.) Parameters for all three screens are described following Table 9-3.Subscriber Parameters1 The software does not verify that the specified RLP/port exists. Make sure the specifiedRLPs and ports are configured in the database, and that they actually exist.Subscriber Nameidentifies the subscriber to the console operator.Routing Algorithmallows creation of a "hunt group" of ports (see example on page 8-24), for the purposeof routing per a pre-selected algorithm:0 = Round Robin – selects ports specified cyclicly in numerical order accordingto the list of Redirection Addresses. If the selected port is unreachable or con-gested, the Call Request will be sent to the next port. (If the port becomesavailable again, it will be included in its assigned position.)1 = Alternate Route on Line Failure – selects the first port that is not in a failedstate. If the selected port does not make a connection, the call will be cleared, evenif other ports are available.2 = Alternate Route on Line Busy – selects the first port that has LCNs available(is not busy). If the port has failed, the next available port will be selected.3 = Least LCN with Throughput – selects the line with the minumum loading, cal-culated by weight and number of LCNs in use on that line. (Each line is assigneda weight proportional to its throughput within the routing path.)If use of a routing algorithm is not desired, simply accept the default, and specify onlyone routing path.Table 9-3 Subscriber ParametersParameter Valid Values Default ValueSubscriber Name 0–31 characters noneRouting Algorithm 0–3 0Systematic Redirection Y/N NRedirect on Busy Y/N NRedirect on Out of Order Y/N NConnection Priority 0–9 01st, 2nd,etc. Path Configured Y/N NRLP FRX4000: 0 1FRX6000: 0–7 1 0PortPhysical port: 0–7 1Logical port: 8-63 1 0Redirection Address 0,1,etc. valid address none
