Black plate (52,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010The delay that is received after shifting out ofR (Reverse) is approximately 10 seconds. The delaycan be cancelled by performing one of the following:. Pressing a hard key on the navigation system.. Shifting in to P (Park).. Reach a vehicle speed of 7 mph (11 km/h).There is a message on the rear vision camera screenthat states “Check Surroundings for Safety”.Adjusting the Brightness and Contrast ofthe ScreenTo adjust the brightness and contrast of the screen,press the CONFIG hard key while the rear visioncamera image is on the display. Any adjustments madewill only affect the rear vision camera screen.] (Brightness) : Touch the + (plus) or – (minus)screen buttons to increase or decrease the brightnessof the screen._ (Contrast) : Touch the + (plus) or – (minus) screenbuttons to increase or decrease the contrast of thescreen.SymbolsThe navigation system may have a feature that lets thedriver view symbols on the navigation screen whileusing the rear vision camera. The Ultrasonic Rear ParkAssist (URPA) system must not be disabled to use thecaution symbols. If URPA has been disabled and thesymbols have been turned on, the Rear Parking AssistSymbols Unavailable error message may display. SeeUltrasonic Rear Parking Assist (URPA) on page 3‑46.The symbols appear when an object has been detectedby the URPA system. The symbol may cover the objectwhen viewing the navigation screen.To turn the symbols on or off:1. Make sure that URPA has not been disabled.2. Shift into P (Park).3. Press the CONFIG hard key to enter the configuremenu options, then press the CONFIG hard keyrepeatedly until Display is selected or touch theDisplay screen button.4. Select the Rear Camera Options screen button.The Rear Camera Options screen will display.5. Touch the Symbols screen button. The screenbutton will be highlighted when on.3-52InformationProvidedby:
