Black plate (5,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010Turn and Lane-Change SignalsAn arrow on theinstrument panel clusterflashes in the direction ofthe turn or lane change.Move the lever all the way up or down to signal a turn.Raise or lower the lever for less than one second untilthe arrow starts to flash to signal a lane change. Thiscauses the turn signals to automatically flash threetimes. It will flash six times if tow-haul mode is active.Holding the turn signal lever for more than one secondwill cause the turn signals to flash until you release thelever.The lever returns to its starting position whenever it isreleased.If after signaling a turn or a lane change the arrowsflash rapidly or do not come on, a signal bulb could beburned out.Have the bulbs replaced. If the bulb is not burned out,check the fuse. See Fuses and Circuit Breakers onpage 7‑110.Turn Signal On ChimeIf the turn signal is left on for more than 3/4 of a mile(1.2 km), a chime will sound at each flash of the turnsignal and the message TURN SIGNAL ON will alsoappear in the Driver Information Control (DIC). To turnthe chime and message off, move the turn signal leverto the off position.Headlamp High/Low-Beam Changer53 (Headlamp High/Low Beam Changer): Tochange the headlamps from low to high beam, pushthe lever toward the instrument panel. To return tolow-beam headlamps, pull the multifunction lever towardyou. Then release it.When the high beams areon, this indicator light onthe instrument panelcluster will also be on.4-5InformationProvidedby:
