Messages regarding paperThe roll is empty.Cause Corrective ActionThere is no more paper left on the roll. Follow the steps below to replace the used roll with anew roll of the same type and size.1.Remove the roll.(→P.186)(→P.181)2.Load the new roll.(→P.182)3.If no barcode was printed on the roll, specify thepaper type.(→P.188)4.If no barcode was printed on the roll, specify thepaper length.(→P.189)Rewinding error.Cause Corrective ActionThere is some foreign object near the Media Take-upUnit sensor and the roll cannot be detected.Remove the foreign object near the sensor.The Media Take-up Unit sensor is soiled and the rollcannot be detected.Wipe the sensor with a dry cloth to clean it.The roll is out of range of detection of the MediaTake-up Unit sensor.Reload the roll. (→P.182)The Media Take-up Unit sensor is damaged. Contact your Canon dealer for assistance.* Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printingnot to stop, set Skip Take-Up Err to On.Turn on the media take-up unit.Cause Corrective ActionThe Media Take-up Unit was off when you selectedEnable for Take-up Reel .Turn the Media Take-up Unit on.Media take-up unit ready.Cause Corrective ActionPress the Stop button and stop printing.The mode switches from take-up mode to regularmode after you change the Take-up Reel setting inthe MAIN MENU from Enable to Disable and lift theRelease Lever , or after you execute Paper Cutting .The Take-up Reel setting in the printer MAIN MENUwas changed from Enable to Disable , but a print jobwas received before the roll was removed.Press the Online button to resume printing.776 Error Message
