Note• The subnet mask and default gateway are set to 0.0.0.0. Use RemoteUI to change the subnet mask and de-fault gateway to match your network settings.For details on RemoteUI, see "Using RemoteUI." →P.872Configuring TCP/IPv6 Network SettingsWhen printing in a TCP/IPv6 network, you must configure the TCP/IPv6 settings on the Control Panel.Follow the steps below to configure the TCP/IPv6 network settings.1. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2. Press the OK button.The Set./Adj. Menu is displayed.3. Press ▲ or ▼ to select Interface Setup, and then press the OK button.4. Press ▲ or ▼ to select TCP/IP, and then press the OK button.5. Press ▲ or ▼ to select IPv6, and then press the OK button.6. Press ▲ or ▼ to select IPv6 Support, and then press the OK button.7. Press ▲ or ▼ to select On, and then press the OK button.Important• Once you set IPv6 Support to On, the IPv6 StlessAddrs setting takes effect.• You can also configure IPv6 StlessAddrs and DHCPv6 from the printer Control Panel.• The DNS can also be configured from the printer Control Panel.Using RemoteUIEnter the printer's IP address in a web browser to display the RemoteUI page. After you log on to RemoteUI from the page,you can check and change the status of the printer and print jobs, and configure network settings.To access RemoteUI, start the web browser and enter the following URL in the Location (or Address ) box to display theRemoteUI page.http://printer IP address or name/Network Setting > Network Setting >Configuring TCP/IPv6 Network Settings iPF63009872