Users in CanadaxiiUsers in CanadaPre-installation requirements for Canon facsimile equipmentA. LocationSupply a suitable table, cabinet, or desk. See the Appendix for the machine’s dimensions and weight.B. Order information1. Provide only a single-line to touch-tone or rotary telephone set terminated with a standard 4-pin modular phone plug.(Touch-tone is recommended if available in your area.)2. Order an CA11A modular jack, which should be installed by the telephone company. If the CA11A jack is not present,installation cannot occur.3. Order a normal business line from your telephone company’s business representative. The line should be a regularvoice grade line or equivalent. Use one line per machine.DDD (DIRECT DISTANCE DIAL) LINE-or-IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE OVERSEASNOTECanon recommends an individual line following industry standards [e.g., the 2500 (touch tone) or 500 (rotary/pulse dial) telephones]. Adedicated extension off a PBX machine without “Camp On” signals is also permissible with your FAXPHONE L170. Key telephone systemsare not recommended because they send non-standard signals to individual telephones for ringing and special codes, which may cause afax error.C. Power requirementsThe power outlet should be a three-prong grounded receptacle (Single or Duplex). It should be independent from copiers,heaters, air conditioners or any electric equipment that is thermostatically controlled. The rated value is 120 volts and 15amperes. The CA11A modular jack should be relatively close to the power outlet to facilitate installation.
