52Setting duplex printing from the printer control panelYou can set the printer for duplex printing by using the Printer Setup feature fromwithin your software application program running under Microsoft Windows 98/95,or Windows NT version 4.0. Alternatively, you can set duplex printing from theprinter’s control panel.Follow the procedure below to use the printer’s control panel to select a pageorientation and turn duplex printing on and off.1 Press Go to take the printer off-line. The On Line indicator should be off. TheREADY message will change to PAUSED.2 Press Menu. PCL MENU will appear in the top line.3 Select a page orientation. Press Item until you see ORIENTATION in the top line.4 Press Value to select PORTRAIT or LANDSCAPE in the bottom line. Press Enter.5 Press Menu until you see FEEDER MENU in the top line.6 Press Item until you see the duplex printing item in the bottom line.If DUPLEX does not appear in the menu, this means the Duplex UnitDU-52 is not installed correctly.For details, refer to the Getting Started Guide for installation procedures.7 Press Value to select DUPLEX=ON in the bottom line and press Enter.8 Press Item to display the binding setting (BINDING) in the bottom line.9 Press Value to enter your selection. Select LONG (long edge binding) or SHORT(short edge binding).Press Enter. The printer is set for duplex printing with the binding method youselected.10 Press Go to put the printer back on-line.11 Use your application software program to start the print job.Duplex Printing
