Chapter 44-94.4.3 Feed Frame Unit4.4.3.1 Removing the Feed Frame Unit 0011-5238LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-Base MF6560PL / / LaserBase MF6580PL1) Detach the front cover, rear cover, open/close cover, and pickup tray.2) Disconnect the five connectors [1].F-4-193) Remove the two front screws [1], two rear screws [2], and two groundingscrews [3] to remove the feed frame unit [4].F-4-204.4.4 Drive Unit4.4.4.1 Removing the Drive Unit 0011-5239LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-Base MF6560PL / / LaserBase MF6580PL1) Remove the feed frame unit.2) Remove the three screws [1], and then remove the drive unit [2].F-4-21When reinstalling the drive unit, make sure that the pickup solenoid lockplate [1] is engaged with the gear.F-4-224.4.5 Pick-up/Feed Roller Unit4.4.5.1 Removing the Pickup/Feed Roller Unit 0011-5230LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-Base MF6560PL / / LaserBase MF6580PL1) Remove the open/close cover.2) Remove the shafts, and then remove the two shutters [1].3) Press the support plate with your fingers to remove the shaft [2], and thenremove the pickup/feed roller unit [3].F-4-23When reinstalling the pickup/feed roller unit, care should be taken to the fol-lowing:1. The arms [4] must be behind the shutters [1].2. The arms [4] must be behind the ribs [5].4.4.6 Pick-up Roller4.4.6.1 Removing the Pickup Roller 0011-5234LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-[1] [1][1][1][3][4][2][1][2][1][1][3][4] [4][2][5][5]Download Free Service Manual And Resetter Printer at http://printer1.blogspot.com